Beurer BM 96 Cardio Mode D'emploi page 50

Performing the blood pressure measurement
• As described above, attach the cuff and adopt the correct posture.
• Press the START/STOP button
ter 4.6.
• After you have made your selection, press the START/STOP button
shown in the display.
• After approx. 3 seconds, the measurement starts automatically.
– The cuff automatically inflates. The measurement is taken while the cuff is being pumped up.
As soon as a pulse has been detected, the pulse symbol
cuff air pressure will be released again.The measurement results for systolic pressure, diastolic
pressure and pulse will be displayed.
– The device has a cuff position control. This function allows the device to automatically check
the correct fit of the cuff on your upper arm during the measurement. If the cuff has been cor-
rectly applied, the symbol
measurement has been completed successfully and is then displayed together with the meas-
ured values determined.
If the cuff is applied too tightly or too losely, the symbol
the display. In such cases, the measurement is cancelled after approx. 5 seconds and the device
switches itself off. Apply the cuff correctly and take a new measurement.
– The systolic pressure, diastolic pressure and pulse rate measurements are displayed. A symbol
is displayed to indicate whether you were sufficiently relaxed during the blood pressure meas-
urement (
chapter 5.4, section "Resting indicator".
– You can cancel the measurement at any time by pressing the START/STOP button
– appears if the measurement could not be performed properly. Observe the chapter "What if
there are problems?" in these instructions for use and repeat the measurement.
• To switch off the device, hold the START/STOP button
til the device switches off automatically. The measurement is automatically stored in the selected
user memory.
ait for at least 1 minute before taking another measurement.
W
once and select the desired user memory as described in chap-
will appear during the inflation process. It remains there until the
= sufficiently at rest;
will be shown together with
= not at rest). Details on this function can be read in
for 3 seconds or wait for 1 minute un-
50
two more times until
will be displayed. After this, the
is
BP
in
.