14.5.2
Avoiding radio interference
14.6 Assembly of the accessories
14.6.1
Grill rack and drip pan
14.7 Electrical connection
caso MLG 23 Touch black
The device can cause the occurrence of interference in radios,
televisions or similar devices.
Such faults can be rectified or reduced as a result of employing
the following measures:
•
Clean the door and the sealing surfaces of the device.
•
Set the radio, the television, etc as far as possible away from
the device.
•
Connect the device to a different electrical outlet, so that
various power circuits are used for the device and the receiver
with the interference.
•
Use a properly installed antenna for the receiver, to ensure
good reception.
► The operation of the device is possible with grill.
► Please only use the grill rack when grilling.
•
Please push the grill rack into the oven.
•
In case of using the grill always put the drip pan under the grill.
In order to ensure the safe and trouble-free operation of the
device, the following instructions must be observed for the
electrical connection:
•
Before connecting the device, compare the connection data
(voltage and frequency) on the rating plate with those of your
electrical network. This data must agree in order that no
damages occur in the device
If in doubt, ask your qualified electrician.
•
The electrical outlet must be protected by a 16A safety cut-out
switch.
•
The connection between the device and the electrical network
may employ a 3 meter long (max.) extension cable with a cross-
section of 1.5 mm². The use of multiple plugs or gangs is
prohibited because of the danger of fire that is involved with
this.
Please note
67