Ego Power+ BA1400T Mode D'emploi page 6

EN BA1400T:
BA2240T:
BA2242T:
Battery
BA2800T:
weight
BA4200T:
BA5600T:
BA6720T:
DESCRIPTION
KNOW YOUR LITHIUM-ION BATTERY PACK (Fig. A)
1. Cooling Air Port
2. Positive Contact
3. Negative Contact
4. Power Button
5. 5-LED Indicator
OPERATION
5-LED INDICATOR ON BATTERY PACK
This lithium-ion battery pack is equipped with a 5-LED
indicator, press the power button to display the charge
level or its working condition, the LED indicator will be
illuminated for 10 seconds
Battery charge
level/Working
indicator
condition
80% ≤ Charge
level ≤ 100%
60% ≤ Charge
level <80%
40% ≤ Charge
level < 60%
20% ≤ Charge
level < 40%
10% ≤ Charge
level < 20%
Charge level <
10%
Low voltage
6
56 VOLT BATTERY — BA1400T/BA2240T/BA2242T/BA2800T/BA4200T/BA5600T/BA6720T
1.30 kg
1.90 kg
2.20 kg
2.25 kg
2.90 kg
3.50 kg
3.65 kg
5-LED
Remarks
5-LED shining green
4-LED shining green
3-LED shining green
2-LED shining green
1-LED shining green
1-LED flashing red.
5-LED flashing red.
The battery pack is nearly
depleted and needs to be
charged immediately.
Over
temperature
Self
-
maintenance
BATTERY PROTECTION
The battery circuitry protects the battery pack from extreme
temperature, over-discharge, and over-charge. To protect
the battery from damage and prolong its life, the battery
pack circuitry will turn off the battery pack if it becomes
overloaded or if the temperature becomes too high during
use. This may happen in extremely high torque, binding,
and stalling situations. The battery pack will shut down with
power indicator shinning red for 10s when its operating
temperature exceeds 70°C, and will begin normal operation
when it returns to 67°C.
Notice: A significantly reduced run time after fully charging
the battery pack indicates that the batteries are near the end
of their usable life and must be replaced.
COLD WEATHER OPERATION
This Lithium-Ion battery pack will provide optimal
performance in temperatures between 10°C and 26°C.
When the battery pack is very cold, it may "pulse" for the
first minute of use to warm itself. Put the battery pack on
a tool and use the tool in a light application. After about a
minute, the battery pack will have warmed itself and will
operate normally.
WHEN TO CHARGE THE BATTERY PACK
NOTICE:
Lithium-Ion battery packs are shipped partially
charged. Before using it the first time, fully charge the
battery pack.
5-LED shining red.
Cool the batter pack until
the temperature drops
below 67°C.
For BA1400T/BA2242T/
BA2800T/BA4200T/
BA5600T/BA6720T 5
LEDs shine solid red for
10 seconds, then go out
and remain off for 10
seconds, then shine solid
red for 10 seconds again
or 5 LEDs flash green
every two seconds based
on different battery
version. Both indications,
the LEDs will run the
cycle until the self-
maintenance is finished.
For BA2240T no special
indicator.