Initialization With The Easy Base Unit - Gewiss Chorus GW 10 761 Manuel D'installation Et D'emploi

INST LL TION INSTRUCTIONS
4. Insert the bus connector into the special feet of the device. The fastener guides
determine the direction it should be inserted.

Initialization with the Easy base unit

1. Power up the device using the bus and wait for 5 seconds until it is in full operating
mode
2. Have the system acquire the device with one of the following procedures:
• Automatic acquisition (the device still has the factory settings):
- select the "Application
the Easy base unit: the device will be recognized automatically.
• Manual acquisition (the factory settings have been modified):
- select the "Application
- briefly press (< 2 seconds) the programming key. The programming LED will light
up during the acquisition process.
Programming key
The device acquired by the Easy base unit will be listed, with the number assigned, in the
channels of the "Application
New function" or "Application
Search device" menu in the Easy base unit;
New function" or "Application
66
Edit function" menu in
Programming LED
Edit function" menus.