Completing Installation; Programming With The Easy Base Unit - Gewiss Chorus GW 10 761 Manuel D'installation Et D'emploi

INST LL TION INSTRUCTIONS
Position the timer-thermostat on the support base,
as seen in the figure below, and fix it in place
using the supplied screws.
2
3

Programming with the Easy base unit

Programming the timer-thermostat through the Easy base unit (code GW 90 831).
The timer-thermostat channel to be used in the function that is to be created can be
selected at choice:
• Press the keys together for over >5 seconds to enable the programming mode.
Use the keys to select the channel you wish to use, then press
The corresponding channel will be highlighted in the channel list in the "Application
New function" or "Application
together to exit the programming mode.
• directly from the list of channels of the "Application
Edit function" menus.

Completing installation

1
Edit function" menu. Press the
67
to confirm:
New function" or "Application
U P
E
N
G
L
I
S
H
keys