Sony SVT-96LP Mode D'emploi page 38

Alarm Recording
OFF (in recording mode): the VCR does not
record the alarm data on the tape.
OFF (in playback mode): the VCR enters normal
alarm search mode.
5
Press SEARCH to release the alarm data search
mode.
To return to MAIN MENU from the current
menu
Press MENU again.
To go to the next menu from the current menu
Press MENU V until "NEXT PUSH B" flashes and
press MENU B.
Notes
• When ALARM DATA REC is set to ON, the VCR
automatically rewinds the tape when inserted. While the
VCR is rewinding the tape, "<AL DATA REC>" flashes
on the monitor screen.
< >
A L D A T A R E C
• In ALARM DATA REC mode the VCR does not record
the 101st or higher alarm data, but it does the alarm
operation.
• If the tape on which the alarm data is not recorded is
inserted, a still picture will be displayed at the point where
the recording started.
• If the required alarm count cannot be found, the VCR will
rewind the tape when the tape comes to the end and stop at
the beginning of the tape.
• The ALARM DATA will be reset when:
– the tape is ejected while recording in ALARM DATA
REC mode.
– all the ALARM DATA are recorded.
– ALARM DATA REC is reset to OFF from ON.
• You can use the ALARM DATA list only when the tape is
recorded in 8-hour alarm recording mode and the recorded
section is longer than 20 seconds.
• While recording of the ALARM DATA list is in progress,
the REC indicator lights in the display window.
• In ALARM DATA REC mode, be sure not to press REW
after the cassette on which the ALARM DATA list is
recorded has been inserted. If you do, the recorded
ALARM DATA list may be erased and replaced with new
one.
38