Electric Connections - Glomex weBBoat 4G Plus Manuel D'installation Et D'utilisation

Warning:
- The weBBoat 4G Plus must be fixed to a mount by tightening the screw in the
base of the weBBoat 4G Plus by means of a screwdriver (Fig. 7).
- The installation of the weBBoat 4G Plus near or above a flat metal surface
may result in significant reduction of the Wi-Fi and 3G/4G signal strength.
- Do not mount the weBBoat 4G Plus near metal obstructions that may
interfere with the Wi-Fi signal.
When using the weBBoat 4G PLUS on metal vessels, Wi-Fi signal can be very
weak. For this reason, it is necessary to use an access point (maximum of 4
APs can be used) inside the vessel. These can be connected to an external
network hub (optional) which then connects to the router inside the weBBoat
4G PLUS radome via an Ethernet cable (optional) (Fig. 10).
Fig. 10

Electric connections

For proper functioning of weBBoat 4G Plus, simply connect the antenna
power cable to a 12/24 Vdc source following the guidelines below.
Connect the red (positive) and the black wire (negative) coming out from the
base of weBBoat 4G Plus to the battery through a twin lead power cable. The
connection can be made by soldering or with a crimp sleeve. It is advisable to
have this procedure carried out by a technician.
IMPORTANT: Incorrect connection or reverse polarity on the power supply
will blow the internal fuse of the weBBoat 4G PLUS.
The power line (not supplied) which connects the two wires coming out from
the base of weBBoat 4G Plus must have cables with a cross section of 1.5
mm² by a length up to 10 m, and 2.5 mm² for longer lengths. Minimum
power supply voltage: 9Vdc.
NOTE: To prevent boat battery drain, we recommend attaching the weBBoat
power supply to a fuse panel that can be turned off when the unit is not in
use.
59
weBBoat 4G Plus
GL00236