Makita DVC750L Manuel D'instructions page 10

Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Tool / battery protection system
The tool is equipped with a tool/battery protection sys-
tem. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will auto-
matically stop during operation if the tool or battery is
placed under one of the following conditions.
Overload protection
When the tool is operated in a manner that causes it to
draw an abnormally high current, the tool automatically
stops without any indication. In this situation, turn the
tool off and stop the application that caused the tool to
become overloaded. Then turn the tool on to restart.
Overheat protection
When the tool is overheated, the tool stops automati-
cally. Let the tool cool down before turning the tool on
again.
Overdischarge protection
When the battery capacity becomes low, the tool stops
automatically. If the product does not operate even
when the switches are operated, remove the batteries
from the tool and charge the batteries.
Indicating the remaining battery
capacity
► Fig.4: 1. Battery indicator 2. Check button
Press the check button to indicate the remaining battery
capacities. The remaining battery capacity is shown as
the following table.
Battery indicator status
On
Remaining
capacity
Blinking
The battery
may have
malfunctioned.
Remaining battery
capacity
Off
50% to 100%
20% to 50%
0% to 20%
Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
slide switch actuates properly and returns to the
"OFF" position when the rear of the slide switch
is depressed.
According to your work need, you can choose two types
of the suction power; normal "1" or high "2".
To start the cleaner, set the switch lever to "1" or "2"
side.
To turn off the cleaner, set the switch lever to "O" side.
► Fig.5: 1. Switch lever
Auto-suction stop during wet
suction operation
WARNING:
the float is at work. Using the cleaner with its float
at work for a long time can cause overheat, resulting
in the cleaner deformation. In the worst case, it may
lead to smoke emission or fire.
WARNING:
liquid. Picking up foam or soapy liquid can cause
foam to come out of air exit before the float works.
Continuing to using in this condition may cause an
electric shock and breakage of the cleaner.
The cleaner has a float mechanism that prevents water
from immersing into the motor when picking up more
than a certain amount of water. When the tank is full
and the cleaner no longer picks up water, switch off the
cleaner and empty the tank.
Carriage handle
When carrying the cleaner, carry it by holding the han-
dle on the head. The handle is retractable at the head
when not in use.
► Fig.6
NOTE: When water is in the tank, switch off the
cleaner and empty the tank before carrying. The
water inside may leak.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
Always wear dust mask during
assembly or maintenance.
10 ENGLISH
Do not use for a long time while
Do not pick up foam or soapy