Environment; General Information - Festool DSC-AGC 18 FH Notice D'utilisation D'origine

Always use original Festool
EKAT
spare parts. Order no. at:
4
www.festool.co.uk/service
5
3
2
1
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
When machining mineral materials (e.g. gyp­
sum, etc.), dust deposits may build up in the
power tool housing and on the on/off switch and
harden when exposed to humidity. This may im­
pair the switching mechanism and cause the
power tool to overheat.
► After each machining process, blow out the
inside of the power tool through the vents
and the on/off switch using dry, oil-free
compressed air.
Clean the sanding tools after use.
Keep the contacts on the power tool, charger
and battery pack clean.
If the dust extraction attachment does not au­
tomatically return to its starting position, open
and close it repeatedly to clean it. If the fault
cannot be rectified, send the power tool to the
customer service department.

13 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re­
cycling.
Information on REACH: www.festool.com/reach

14 General information

14.1 Bluetooth
®
The Bluetooth word mark and the logos are
®
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.
English
25