Acoustic Warning Signal; Accessories; Service And Maintenance - Festool DSC-AGC 18 FH Notice D'utilisation D'origine

English
The power tool can be placed down flat on
the dust extraction attachment when not in
use.
► Remove the sanding tool from the power
tool for transport.
9.1 Abrasive cutting
► Always guide the sanding tool through the
workpiece in a straight line.
Ensure that the sanding tool does not tilt
and that it is not loaded at an angle or from
the side.
► Ensure that the plate lies flat on the work­
piece.
9.2 Cuts near edges [6]
WARNING
Risk of injury from exposed sanding tools
► With the exception of cuts near edges, the
dust extraction attachment must only be
used in the locked position and with the
auxiliary handle.
► Remove the auxiliary handle.
► Check to ensure that the moving part of the
dust extraction attachment can be moved
freely using the retractor lever and that it
automatically returns to its starting posi­
tion.
► Hold the power tool in your right hand.
► Switch on the power tool and position it
on the workpiece.
Unlock the retractor lever [6-1] for the
►
dust extraction attachment with your left
hand just before you reach the wall.
► Use the retractor lever to retract the
moving part of the dust extraction attach­
ment while continuing to cut so that you can
get as close to the wall as possible.
This ensures that the dust extraction sys­
tem delivers maximum performance.
► After the cutting work is complete, return
the dust extraction attachment to its start­
ing position using the retractor lever.

10 Acoustic warning signal

If the power tool switches off because of subse­
quent operating statuses, no warning signal
sounds when it switches on.
Battery pack not accepted
– Insert the correct battery pack model.
Battery pack empty
– Change the battery pack.
24
– Charge the battery pack.
Battery pack fault
– Change the battery pack.
– Use the charger to check that the battery
pack is fully functional once it has cooled
down.
Battery pack overheated
– Let the battery pack cool down.
Power tool overheated
– The power tool must cool down before it
can be started again.
Power tool fault
– Contact a Festool service workshop or spe­
cialist dealer.
Power tool jammed
– Eliminate the cause of the jam.
If the power tool switches off when it be­
comes jammed, no warning signal sounds.

11 Accessories

Always use original Festool tools and accesso­
ries. Using low-quality tools or accessories
from other manufacturers may increase the
risk of injury and cause seriously unbalance the
machine, decreasing the quality of the working
results and accelerating machine wear.
The PO numbers of the accessories and tools
can be found in the Festool catalogue or online
at "www.festool.co.uk".

12 Service and maintenance

WARNING
Risk of injury, electric shock
► Always remove the battery pack from the
power tool before performing any mainte­
nance or service work.
► All maintenance and repair work that re­
quires the power tool to be opened up
should always be carried out by an author­
ised service workshop.
Customer service and repairs
must only be carried out by the
manufacturer or service work­
shops. Find the nearest address
at: www.festool.co.uk/service