Filter; Cleaning A Dry Filter; Cleaning A Wet Filter; Cleaning & Disinfecting The - RIDGID WD03180 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance (continued)

Filter

!
WARNING: To reduce the risk of
injury from accidental starting,
remove battery before changing
filter.
NOTE: The filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used
for dry pick up or small amounts of liquid.
Handle the filter carefully when removing
to clean or installing it. Creases in the
filter pleats may occur from installation
but will not affect the performance of the
filter.
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the Vac for dry
material pickup.

Cleaning A Dry Filter

NOTE: For best cleaning results due to
accumulated dust, clean the filter in an
open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
1. Light cleaning of some dry debris from
the filter can be accomplished without
removing the filter from the vac.
Simply slap your hand on top of the
handle while the vac is turned off.
2. Remove filter from vac. Gently tap the
filter against the inside wall of your
dust drum and the debris will loosen
and fall.
3. For thorough cleaning of a dry filter
with fine dust (no debris) you may run
water through it as described under
"Cleaning A Wet Filter" Section.

Cleaning A Wet Filter

After filter is removed, run water through
the filter from a hose or spigot. Take care
that water pressure from the hose is not
strong enough to damage filter.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small
hole can cause a lot of dust to come out
of your Vac. If your filter is damaged or
worn, replace it immediately.
Allow the filter to dry before reinstalling
and storing the Vac or picking up dry
debris.
Cleaning and Disinfecting the

Wet/Dry Vac

To keep your Wet/Dry Vac looking its
best, clean the outside with a cloth
dampened with warm water and mild
soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm
water and mild soap.
3. Wipe out with dry cloth.
Before prolonged storage or as needed
(i.e., waste water pick up) the drum
should be disinfected.
12

Publicité

Table des Matières
loading

Table des Matières