Installation - Brandt TF12700 Guide D'installation Et D'utilisation

Before installing, carefully read the Recommendations and Safety standards in order
to avoid a certain number of problems.
Install the appliance in a dry, well-ventilated room, away from all sources of heat. Leave a
minimum gap of 10 cm between the top of the appliance and any overhead units. If your
installation does not enable you to do this, then leave 5 cm between the top of the appliance
and any other wall-mounted units, and a gap of 2.5 cm on each side of the appliance.
If your appliance is to be installed next to another fridge or freezer, keep a gap of 5 cm on the
sides to prevent condensation forming on the outside of the appliance.
The climate class of your fridge is marked on its ID plate. It determines the range of
ambient temperatures for which the cooling unit is designed, and within which correct
operation of the appliance is guaranteed.
Electrical connection
Connector characteristics: 220-240V with earth.
Avoid using adapters or extension leads.
Avoid the cable coming into contact with the compressor.
Avoid trapping the cable under the appliance.
The appliance's electrical installation is earthed. For your safety, connect the appliance to a
power outlet with effective earthing (in conformity with current electrical installation safety
standards).
The manufacture declines all liability for damage caused by the absence of an earth
connection.
CAUTION – BEFORE CONNECTING
1. Clean the inside of the fridge with warm water containing bicarbonate of soda. Rinse and
dry thoroughly.
2. Wait for 2 hours before switching on, to ensure that the lubricants in the motor
compressor have stabilised.

INSTALLATION

Class
N
ST
T
16
Ambient temperatures
16° to 32°
18° to 38°
18° to 43°