Important - cecotec CONGA 1090 Serie Manuel D'instructions

ENGLISH
• Before operating the robot under spot cleaning
mode, place it on the spot to be cleaned.
• Press the spot cleaning button
control.
4. Edge cleaning
Once the robot has finished cleaning your home's open
areas, it will start cleaning edges, along walls and around
furniture such as table or chair legs. If you want to
activate this mode directly, skipping the previous process,
press the edge cleaning button
on the remote control.
5. Max Power function
Press the button on the remote control in order to
control the robot's suction power during the cleaning
process. The suction power can be increased or decreased.
Daily cleaning scheduling
In order to make cleaning easier, this robot includes daily schedule settings in order for
you to customize the cleaning cycles from the remote control. The robot will start cleaning
automatically the set days at the set time.
*The time options on the remote control are 12:00 am – 11:59 pm and 12:00 pm – 11:59 pm.
*Before adjusting the robot time and settings, make sure the power switch is set at "I" and that
the robot's AUTO button is lit up in blue or green. If it does not light up, press the robot's power
button or turn it on from the remote control.
• Select the current day and time.
• Press the button and the day of the week and the
First, select the day of the week using the direction arrows
• Use the button to switch from fay to week. Then, use the
desired time. Repeat this step to select minutes.
• Once the day of the week and the time is set, press OK or
IMPORTANT: the day of the week will not appear on the display. In order to check if it has
been properly saved, press
Setting cleaning schedule
1. Press the button to enter schedule settings.
24
on the remote
again and make sure the day of the week is correct.
symbol on the display will blink.
and .
and buttons to select the
to save the settings.