Honeywell HEV615 Serie Manuel D'instructions page 3

SETTING UP YOUR HUMIDIFIER
Unpack the Humidifier
Keep this instruction manual for reference.
1. Remove packaging materials.
Locate Float Paddle and set aside.
This is required for operation.
2. Remove twist tie and extend power cord.
Place on a firm, level, water resistant surface
a minimum of 12 inches (30 cm) from walls.
Float Paddle Installation – required for humidifier to operate
This humidifier uses a float system to regulate the water flow from the Tank to the Reservoir.
The Float Paddle must be properly installed for the unit to operate. If not properly installed, water
may not flow into the Reservoir or it may leak from the Base. The Float Paddle is designed to be easy
to install and remove.
CAUTION: Improper placement of the Float Paddle could result in leaking or water
not feeding to the Reservoir.
Step 1 Step 2 Brackets
Float
Paddle
Step 4 Step 5
1. Remove Water Tank.
2. Line up Float Paddle with the float paddle shape on the bottom of the Reservoir.
3. Place Float Rod over the Brackets and press firmly until you hear it click into place.
4. Pull gently up on the Float Rod to be sure it doesn't pop out of the Brackets.
5. Place Water Tank back in Base.
FILLING/REFILLING THE WATER TANK
DO NOT ADD ESSENTIAL OILS to the water tank. Doing so could cause damage to the
humidifier and void the warranty.
This humidifier holds a maximum of 1.7 gallons (6.4 liters) of water.
Step 1 Step 2
Step 3
"Click"
Float
Rod
4
FILLING/REFILLING THE WATER TANK
The Tank can be filled in two ways:
Option 1: At the Humidifier Option 2: At the Sink
Option 1 Option 2
Both filling options can be performed with or without the Tank Cover in place. Be sure to
replace the Cover before using the humidifier to keep opjects and debris out of the water.
Note: Ensure the Float Paddle has been placed correctly in the Reservoir before filling.
See Float Paddle Installation instructions if necessary
Consumer assumes all responsibility for property damage resulting from improperly
filled humidifier.
Option 1: To Fill Tank at the Humidifier
Step 1
1. Pour cool water from a pitcher or jug directly into the Water Tank. It is not necessary
to remove the Tank Cover. DO NOT overfill.
CAUTION:
DO NOT pour water into the Grill
Option 2: To Fill Tank at the Sink
Step 2
Step 1
1. Grasp Tank Handle and pull Tank forward to remove from Base. Carry Tank to sink.
2. Remove Tank Cover if desired. Tank may also be filled through the openings in the
Tank Cover.
3. Fill Tank with cool water. DO NOT overfill. Replace the Tank Cover if it was removed.
4. Carry Water Tank back to humidifier and replace on Base.
CAUTION:
Use care when handling Water Tank to avoid unnecessary impact.
Banging or dropping the Water Tank could result in damage to the Tank that
may cause leaking.
(CONTINUED)
x
✔
Step 3 Step 4
5