MTD 19A30034000 Manuel De L'utilisateur page 9

IMPORTANT:
Be certain that the bottom of
the discharge chute is located inside of the lip
of the deck opening, as shown in Figure 4-14.
Figure 4-14
Securing the Boot to the Deck
1. Secure the end of the strap utilizing the
hole furthest from the end, insert the
torsion spring hook (732-04510A) into the
other end. repeat process for rear strap as
shown in Figure 4-15.
NOTE: Be certain that if your deck is the 42"
model that you utilize the hole furthest to
the rear of the mower when connecting the
rear strap.
2
Figure 4-15
IMPORTANT:
Be certain that the bottom of
the discharge chute is located inside of the lip
of the deck opening, as previously shown in
Figure 4-14.
Installing the Upper Chute Tube
NOTE: Check the upper chute for a cardboard
insert installed for shipping purposes. If the
insert is present, remove it before continuing
with Step 1.
1. Peel the backing off of the self-adhesive
foam strip (721-04388) that has been
included within your Contents of Carton.
Apply it to the upper chute, flush against
the flange as shown in Figure 4-16.
Flange
Figure 4-16
2. With the grass catcher cover open, install
the upper discharge chute through the
discharge chute opening, as shown in
Figure 4-17.
1
3. With the ability now to wiggle the
discharge chute tube back and forth, slide
it over the chute elbow mounted on the
3
cutting deck, as shown in Figure 4-18.
4. Continue to work the discharge chute
down over the chute elbow until the
groove on the discharge chute aligns with
the upper chute support, as shown in the
inset of Figure 4-19.
5. Close the grass catcher cover.
S 4 — A
ection SSembly
Figure 4-17
Figure 4-18
Figure 4-19
& i 9
nStAllAtion