Assembly & Installation - MTD 19A30034000 Manuel De L'utilisateur

Assembly & Installation
Assembling Bag Hanger
1. Install the hanger assembly onto the
upright support assembly using a
carriage bolt (710-0276) and wing
knob (710-04122) from hardware
pack 689-00579. See Figure 4-1.
Figure 4-1
Installing Mounting Hardware
1. Install the 4 shoulder screws (738-
05243) into the screw holes located
on the rear of the tractor frame as
shown in Figure 4-2.
Figure 4-2
Installing the Upright Support
1. Slide the Upright Support Assembly
(819-010511) onto the shoulder
screws. Once engaged, push down
on the assembly to secure it in place
as shown in Figure 4-3.
NOTE: Make sure that the spring clip
is engaged in hole.
2
1
Figure 4-3
Assembling Remaining Bagger
Components
Follow these steps to assemble the
remaining bagger components.
1. Snap the plastic upper chute support
in place by first clipping the side
portion onto the bagger support rail
with the edge of the snap feature
aligned with the red line, as shown in
1 of Figure 4-4.
2. Snap the front side of the chute
support to the rail, as shown in 2 of
Figure 4-4.
2
Figure 4-4
3. Install the grass catcher cover onto
the bag support assembly, as shown
in Figure 4-5. The grass catcher cover
goes inside of the two mounting
tabs on the bag support assembly.
Figure 4-5
4. Slide the hinge pin into the hole
located on the mounting tab, as
shown in Figure 4-6. Use the cut-out
window (See inset in Figure 4-6) to
line up the hinge pin on the other
side and push pin all the way in until
it reaches the end-stop.
Figure 4-6
1
5. At this point the pin clips into place
and is secured by a tab in the bagger
cover. See Figure 4-7.
Figure 4-7
4
7