MTD 19A30034000 Manuel De L'utilisateur page 8

6. If not already flipped forward, flip seat
forward to allow for the grass bags and
upper tube assembly steps.
7. Open bagger cover by pushing in on the
rear, right-side tab with your right hand,
as shown in (1) of Figure 4-8, and lifting
the cover with your left hand in the center
rear of the bagger cover (2).
2
Figure 4-8
8. Install both grass bag assemblies, with
the tight mesh sides facing forward, onto
the bag support brackets by inserting the
front edge in first, as shown in Figure 4-9,
and setting the back edge down until it
fits into the assembly.
1
2
Figure 4-9
8 S 4 — A
ection SSembly
Installing the Deck Chute
1. Determine whether your deck is a 42" or
46" model. As shown in Figure 4-10, a 46"
deck will have a mounting tab with 1 hole
(1), while a 42" deck will have a mounting
tab with 2 holes (2).
1
2. If your mower deck is 46", you will need
to remove the 42" deck boot adapter
that is pre-installed in this kit. Remove 3
nuts (712-0380) and 3 T30 screws (710-
1193A) with the included T30 Wrench
(727-05140). Slide out the boot adapter
from boot. Re-install 3 nuts (712-0380)
and 3 T30 screws (710-1193A), as shown in
Figure 4-11.
& i
nStAllAtion
1
2
Figure 4-10
Figure 4-11
3. Install the rubber chute straps, from
hardware pack 689-00579, onto the chute
elbow using the clevis pin (711-05063),
washer (736-0204) and Bow-tie cotter pin
(714-04040) from the hardware pack. See
Figure 4-12.
Figure 4-12
4. Secure the chute elbow to the deck by
aligining the tab slot in the boot, and the
tab located on the mower deck as shown
in Figure 4-13.
5. With the tractor's discharge chute raised up
and held open (1), install the chute elbow
shown in Figure 4-13.
Figure 4-13
1
2