Fault-Finding Plan; Warranty - AL-KO TCS Duotec 2500 Mode D'emploi

Fault-Finding plan

FAULT-FINDING PLAN
Fault
Motor won't start
Reduced cutting performance
CAUTION!
Electrical repairs should only be carried out by a qualified electrican or authorized service agent!

WARRANTY

We will address claims for any defects in materials and workmanship during the statutory period of limi-
tation by means of repairs or replacements of our choice. The period of limitation is governed by the laws
of the country in which the machine was purchased.
Our warranty applies only if:
The machine has been properly handled
The operating instructions have been adhered
to
Original replacement parts have been used
The warranty does not cover:
Damage to paint work through normal use
Parts subject to wear as indicated in the replacement parts list with a box [xxx xxx (x)]
Internal combustion engines – separate warranty conditions of the respective engine manufacturer
apply
The warranty period begins with the purchase by the first buyer. The warranty period begins on the date
that appears on the original purchase receipt. In the event of a warranty claim, please your contact sup-
plier or the nearest authorised customer service centre with this warranty declaration and the purchase
receipt in hand. This warranty does not affect the legal warranty claims by the purchaser against the
seller.
456251
Possible cause
no mains voltage
mains cable / plug
coupling faulty
Housing not closed as required
- safety switch in operation.
blade disc blocked
blunt blades
The warranty is no longer in effect if:
Remedy
check fuse
check (electrical expert)
replace
Close housing as required and
screw down firmly.
Remove any shreddings from in-
side the housing (Attention! Re-
move mains plug).
Regrind blades or replace with
new ones.
Efforts have been made to repair the machine
Technical modifications have been made to the
machine
The machine has not been used for its intended
purpose
21