Safety Warnings During Use And Installation; Clothing - Ultraflex UP 20 F Manuel D'installation Et D'entretien

ULTRAFLEX
4 SAFETY WARNINGS
This section shows the safety rules which must be followed for the correct equipment operation.
We recommend reading carefully this section and also the other manuals supplied with the steering system
components.

4.1 Safety warnings during use and installation

RESPECT STRICTLY the following safety rules.
ULTRAFLEX declines all responsibility in case the user does not follow these rules and it is not responsible
for negligence during the use of the system.
DANGER
- DO NOT PUT HANDS BETWEEN THE MOVING PARTS.
- Do not disable the safety devices.
Do not modify or add devices to the system, without ULTRAFLEX written authorisation or technical
-
intervention which will prove the modification.
- Do not use the equipment for a purpose different from the one it has been designed for, which is
specified in the installation and maintenance manual.
- Do not let non-specialized staff perform the installation.
- Do not disassemble the hydraulic connections before bleeding the oil in the system completely.
The hoses can contain high pressure oil.
- In case of installation with double station DO NOT use both stations. As a matter of fact the two
stations are always enabled on the steering compartment. The effect of the rudden rotation on
both stations will double causing an undesired manoeuvre.
WARNING
- Do not put the feet on the cylinder.
- Check the system after the installation and the purging but before operating the vessel. Turn the
steering wheel until the cylinder/s reaches/reach the end stroke.
Turn the steering wheel to the opposite direction. Repeat on each installed helm to verify the
correct installation and the system operation.
- Carefully use sealing fluid (such as Loctite). If it reaches the hydraulic system, it may cause
damage and mechanical failure.
- Do not use teflon tape or adhesive tape to seal the fittings, as this material may be injested, by
causing the system fail.
- During the system installation, prevent foreign matters from entering the system.
Even a little object may cause lasting damage that are not detected immediately.
- Avoid too narrow bend radius of hoses.
- Avoid the hose contact with edges or sharp corners.
- Avoid the hose contact with heat sources.

4.2 Clothing

WARNING
During installation, inspection or maintenance, IT IS STRICTLY FORBIDDEN to wear necklaces, bracelets or
ATTENZIONE
clothes which could get caught in the moving parts.
page 20
of 71 -
PUMP FOR HYDRAULIC SYSTEMS
Installation and maintenance manual
!