Klarstein Crossfire Mode D'emploi page 17

CONNECTING A GAS CARTRIDGE
This appliance is only suitable for use with low-pressure butane-propane mix gas and
fitted with the appropriate low-pressure regulator via a flexible hose. (Regulator certified
to BSEN 16129:2013). lf the regulator seals are missing or leaking, it is prohibited
to continue to use. Check the seals before connecting a new gas cartridge to the
appliance.
1. Open the back door, turn the
regulator switch knob clockwise
"-" to min position.
2. Turn gas cartridge clockwise to connect the gas
pressure-valve regulator.
3. Turn the regulator switch knob anticlockwise
"+" to max position to open the gas and turn
the regulator switch knob clockwise "-" to min
position to close the gas.
4. To change the gas-cartridges, turn the regulator
switch knob clockwise "-" to min position and
then turn empty gas cartridge anticlockwise to
disconnect from gas regulator.
IMPORTANT: Cartridges must be stored outdoors in an upright position and out of the
reach of children. The cartridge must never be stored where temperatures can reach
over 50 °C. Do not store the cartridge near flames or other sources of heat.
EN
17