Maintenance; Malfunction Explanation; Operation And Functioning Of The Charging Station - Ecotap Duo Manuel

20. MAINTENANCE

Always disconnect the charging station from the power supply and read the
manual before performing maintenance or fixing a malfunction.
Only products approved by the supplier can be used to repair or replace components.
Repairs and replacements should always be carried out by a certified specialist.
Maintenance should always comply with and be carried out in accordance with NEN3140
and NEN50110 low voltage EU regulations.
Check the charging station for leaks.
Check the connection of the main power cable and ensure a tight connection of at least 3.5
to 5 Nm.
Treat any damage to the charging station with anti-corrosion paint.

20.1 Malfunction explanation

If the charging station is not functioning properly, please contact the back office provider or
contact another certified mechanic with the right measuring and testing equipment with car
simulation.

20.2 Operation and functioning of the charging station

Before connecting the charging station to power, the back office provider
must be contacted to allow the software to be activated. The unique
charging station number is required for this.*
*Only applies to charging systems with registration.
As soon as registration has been completed, the charging station can be used with any type
of electronic transport charging card (EV charging card/charging key) or another suitable fuel
card (other options available).
Operation: Activate the start/stop procedure by holding the charging card or charging key in
front of the scanner. You will hear a single acoustic signal and the light will blink green.
With type 2 sockets, the inserted plug is locked into the charging socket. Subsequently, the
charging station communicates with the vehicle and the BackOffice system. Once all safety
and payment regulations have been checked, the maximum allowed charging current is
listed.
The charging procedure starts automatically and the light turns blue. (Other options are
possible).
To stop the charging procedure, hold your card in front of the scanner. You will hear two
acoustic signals, the light will blink green and the plug is unlocked. You can now remove the
plug.
The push button/auto-start operation replaces the scanner and charging card/charging key
and does not require BackOffice verification.
21. www.ecotap.nl
14/04/22