Maintenance; Transportation And Storage; Resolving Problems; Operation Of The Charging System - Ecotap Homebox Manuel

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

20. MAINTENANCE

Always switch off the power and read the user manual before carrying out
maintenance or fixing problems.
Only products approved by the supplier must be used for
repairs or replacement of components.
Repairs and replacements must be carried out by an
authorised employee / installer. All maintenance work must be carried
out in compliance with the NEN3140 and NEN 50110 Euro standards for
low-voltage equipment.
Treat any damaged surface areas of the Homebox with anti-corrosive paint.

21. TRANSPORTATION AND STORAGE

Transport the Homebox in the box it was delivered in. When shipping the Homebox, apply a
clear indication that the item must be handled with care.

22. RESOLVING PROBLEMS

If the charging system does not work properly, you can contact back office provider or an
authorised installer in possession of measurement and testing equipment with car simulati-
on.

23. OPERATION OF THE CHARGING SYSTEM

The Homebox can be operated either with a charging pass or with the
button, or the system is self-starting.
The Homebox version "Laden Met Registratie / LMR" (Charging with
registration) needs to be registered.
This registration is possible by calling Ecotap® B.V. during office hours.
Tel. +31 (0) 411 74 50 20.
As soon as registration is completed, the Homebox can be used with any Electric Transport
charging pass, or other suitable pass.
When the Homebox is not in use, a green light will flash regularly.
Operation:
The charging procedure can be started and stopped by holding the charging pass in front of
the scan point, or by pressing the Start button (only for the version with a Start button). You
will hear 1 audio signal and the light starts blinking green.
With the version with a type 2 socket, the plug is locked in the type 2
charging socket. The charging system then communicates with the vehicle and with the back
office system. Once all safety and payment conditions have been checked the maximum
allowed charging current is released.
The charging procedure is automatically started and the light will flash blue.
To stop the charging process, hold your pass in front of the scan point or press the button
(only for the version with a button). You will hear 2 audio
signals, the light starts to blink green and stops when the plug is unlocked. You can now
remove the plug.
21. www.ecotap.nl
14-04-22

Publicité

Table des Matières
loading

Table des Matières