Safety Device; Safety; Safety Regulations; Mandatory Checks Before Initial Use - Ecotap Duo Manuel

15.3 Safety device

• Fuse holder
• 12 Volt control voltage
• Components at least IP2
• Strain relief
• 3,7 mm steel casing
• IP54 lowest waterproof category of the type 2 sockets

16. SAFETY

Read the following safety regulations carefully before you install and use the
charging station.

16.1 Safety regulations

Before you install the charging station, you must make sure the location is safe for all
bystanders. NEVER allow children onto this worksite. Never allow ANYONE who has nothing
to do with the work onto the worksite.
- Never be distracted while you are performing the work.
- Make sure you maintain a healthy posture at all times while doing the work.
- Do not leave any tools or charging station components unattended.
- Make sure any tools you are using are clean and dry.
- Make sure that the charging station, tools and components will stay dry
when it is raining.
Make sure that there is no danger of anyone tripping over objects or paving
while you are digging the hole for the foundation.
Make sure to wear good, suitable gloves for any special actions throughout
the entire installation and connection process.
Always check any measuring instruments you will be using to disconnect
the installation from its power supply before you use them, checking them
several times to make sure they are working properly.

17. MANDATORY CHECKS BEFORE INITIAL USE

The following checks are required to be performed before the charging
station is installed and/or used. NEVER use the charging station if, during
one or more of these checks, the power supply or stability of the charging
station does not comply with safety regulations.
17. www.ecotap.nl
14/04/22