User / Installation Manual; Required Power Cable; Wall Mounting - Ecotap Duo Manuel

√ All work described below is in compliance with NEN 3140.
√ Check whether the wires have been connected to the terminals in the right order.
√ Check whether the cores have been properly tightened, 3.5 to 5 Nm.
√ Check whether the grounding connector has been connected to the
coded terminal and whether it has been connected to the grounding
electrode or the supplied grounding device. The entire grounding system
must comply with the NEN1010/EU/35.
√ Check whether the cable thickness of the power cable matches the fused
current rating.
√ Check whether the charging station is tightly and properly secured.
√ Check whether the station is sufficiently waterproof.
√ Keep the immediate environment of the work area free from obstacles.

18. USER / INSTALLATION MANUAL

18.1 Required power cable

The power cable has to be connected to a separate power group.
When using a machine this should be C characteristic or equal, the height of the current
rating depends on the length and the available power on site.
PLEASE NOTE: the charging station requires only 1 power cable. Please take
into account the cables and groups will be under full load for several hours.
Cabling will have to be implemented in accordance with current standards, such as
NEN1010.
Exceptions to the NEN1010 standard are:
• Cable thickness deviates
• Grounding spread resistor < 30 Ohm.
• Installation resistor < 1 Ohm.
• Voltage drop max. 2%.

19. WALL MOUNTING

We recommend mounting the charging station to the wall at a height of +/- 85 centimetres,
measured from the bottom of the charging station.
When mounting the charging station, you should take into account the strength of the wall.
The wall should be completely closed, without any holes or openings. If these are present,
they must first be filled.
Use the right fastening screws to firmly secure the charging station to the wall and use all
four fastening holes. Mounting material is included.
First, remove the cover with a torx screw at the bottom. The charging station can now be
mounted to the wall.
18. www.ecotap.nl
14/04/22