Hydraulic Data - Hitecsa EWMIG 236 Manuel D'installation, D'utilisation Et D'entretien

Example with a 3-way valve on the last terminal
The sizing of the By-PASS is up to the installer; it is in any case recommended to include a calibration valve to balance the system.
Pump set up with the V3V accessory
The units in heat pumps, with Pump P1-P2-PI1-PI2 set up (single electropump), can be supplied with a factory-fitted 3-way diverter valve. This way it is
possible to manage the production of domestic hot water without the addition of external valves.
2
II.6.5

HYDRAULIC DATA

Model
Safety valve calibration of channelled water
Heat exchanger water content
Expansion tank capacity
Expansion tank pre-load
Expansion tank maximum pressure
Water tank content ASP1/ASP2 ASPI1/ASPI2
Minimum water flow (intervention differential water)
The expansion tank on the machine has limited capacity to protect the hydraulic circuit inside the machine. It is the installer's duty to size and install an
expansion tank that is suitable for the system.
4
SECTION II: INSTALLATION AND MAINTENANCE
Example with a Bypass on the circuit
BY-PASS
1
2
3
4
1
3
236
barg 3
l 3,2
l 14
barg 1
barg 3
l 80
l/h 4700
38
Compact-I
Inertial storage tank (if necessary)
Domestic
Technical water storage tank
Connections place ACS – V3V
245 250 260
3 3 3
3,2 3,8 5,1
14 14 14
1 1 1
3 3 3
150 150 150
4700 4700 4700