Important; Safety Instructions; Alarm.com Introduction; Ip/Hspa 3G Module - Tl8803Gi - Tyco TL8803GI Mode D'emploi

Important

This installation manual shall be used in conjunction with the control panel installation manual available online
from the DSC website at www.dsc.com. All the safety instructions specified within that manual shall be
observed. The control panel is referenced as the "panel" throughout this document. This installation guide
provides the basic wiring, programming and troubleshooting information.
The alarm communicator is a fixed, wall-mounted unit, and shall be installed in the location specified in these
instructions. The alarm communicator module should not be installed inside of a metal enclosure , doing so will
significantly impair cellular and RF (Z-Wave) transmissions.

Safety instructions

Read the safety information before you install the equipment.
Important: This equipment must be installed by a skilled person only. A skilled person is an installer with
appropriate technical training. The installer must be aware of potential hazards during installation and meas-
ures available to minimize risks to the installer and other people.
• Before you install this equipment, disconnect all power sources (for example mains, battery, and telephone
line) connected to the alarm panel.
• Install the equipment indoors in a non-hazardous environment where the following conditions are met:
- Pollution degree - Maximum 2
- Over voltages - Category II
• Internal wiring must be routed to prevent strain on wire and terminal connections, loose terminal connections,
and damage to conductor insulation.

Alarm.com introduction

The purpose of this guide is to provide installation and operating instructions for the Alarm.com communicator
module. The following sections offer you a brief overview of its capabilities. Some capabilities and features
vary based on the Alarm.com service plan selected. Visit www.alarm.com/Dealer or contact Alarm.com for
more information.
Note: The Dual Path IP/HSPA 3G module is available in the models TL8803GAT-LAT N (for use in South
America) and TL8803GI.
Note: Image sensor functionality may not be enabled in all regions.
The module TL8803GI contains the IP/Radio subassembly and the PC-Link to RS422 conversion interface.
The module is compatible with NEO Alarm Control Unit models: HS2128, HS2064, HS2032, HS2016 soft-
ware versions 1.1 and above, and Powerseries Pro models: HS3032, HS3128, HS3248.

IP/HSPA 3G module - TL8803GI

The Dual Path module enables wireless reporting of all alarms and other system events from the DSC Neo con-
trol panel using an all-digital, HSPA wireless (cellular) network or an Ethernet network. The module can be
used as the primary communication path for all alarm signaling, or as a backup to a telephone connection to the
central monitoring station. The wireless alarm signaling and routing service is operated by Alarm.com. The
HSPA module also features integrated support for Alarm.com's home automation solution with built-in
Z-Wave capabilities.

Contact information

For additional information and support on Alarm.com modules, initial account setup, home automation, and all
other Alarm.com products and services, please visit: www.Alarm.com/dealer or contact Alarm.com technical
support at: 1-866-834-0470.
- 4 -