Enroll Alarm.com Image Sensor - Tyco TL8803GI Mode D'emploi

Table des Matières

Les langues disponibles

Installation

Warning: The external antenna must be installed in a manner to prevent end users from accessing any con-

ductive part of the anntena or antenna cable (i.e., recessed mounting or equivalent).

6: Power up

Connect panel battery and AC power. Once powered, view key items on the LCD. Ensure that the module is

fully connected to the alarm panel using quad cable as shown in wiring diagram.

Step 3: Verify installer code to activate Alarm.com module

Alarms and other signals are not sent to Alarm.com until the installer code is verified. To activate the account,

perform the following steps:

1. Connect the Alarm.com module to the panel. Ensure [382] option 5 is ON.

2. Press [*][8] to enter Installer Programming.

3. Enter the installer code.

4. Press [#] to exit Installer Programming.

To remotely activate a system that is already signaling, complete the following steps:

1. Go to www.alarm.com/dealer.

2. Go to the customer's account.

3. Select the error message at the top of the page.

4. Enter the installer code.

Step 4: Perform dual-path test (module registration)

To initiate module communication with Alarm.com and the cellular network for the first time, perform a

"Dual-Path phone test". Note that the test can also be used at any time by the installer to force communication

with Alarm.com. To test the cellular path, press and hold [3] for two seconds. To test the ethernet path, press

and hold [4] for two seconds. A Dual-Path test can also be completed through the Interactive Services menu.

To perform the Dual-Path test, press [*][6] followed by the master code and [04].

The panel indicates when the test has completed by activating the siren output on medium volume for 2 seconds

followed by full volume for 2 seconds. However, if the test was initiated via the [3] or [4] key, or through the

Interactive Services menu, the siren does not sound. All display lights and LCD pixels turn on. This indicates

that Alarm.com has received and acknowledged the signal. This does not guarantee that the signal went

through to a central station; it confirms that Alarm.com's Network Operations Center received the signal. The

central station should be contacted directly to verify that the signal was received on the correct account and

that the central station routing settings have been set up correctly. If the signal does not go through to the cent-

ral station, the panel displays a "Failure to Communicate" message. Double check the account's central station

Forwarding Settings on Alarm.com and contact technical support if the trouble persists.

Step 5: Allow module to auto-program

After a successful dual-path test, wait 2 minutes for the module to automatically program and initialize before

entering the Installer Programming menus. Entering Installer Programming during module initialization will

cancel the process. LCD keypads display a message indicating when auto-programming is occurring and when

it has completed. During the auto-programming session, the module automatically programs panel settings

required for proper functionality with Alarm.com as noted in the "Panel Settings" section.