Axis T92E Serie Guide D'installation page 8

Page 8
Install the camera in the housing
1. Loosen the bottom cover screws and remove the top cover.
2. Loosen the holder screws and remove the holder.
3. Secure the camera and holder with the screws and washer according to the illustrations and
table below. Tighten the stabilizing screw just lightly and tighten the camera screw to 2 Nm. Be
careful not to overtighten the screws.
Camera model
Note:
IO cables and camera holders may vary between different camera models.
AXIS T92E05/AXIS T92E20
Holder position and fasteners
AXIS T92E05/T92E20 Installation Guide
AXIS T92E20
I/O cable
No
Yes
Yes
Yes
Cold Startup Delay
Off (O)
Off (O)
On (I)
On (I)