Technical Characteristics - IPC SG-70 Manuel D'instructions

TECHNICAL CHARACTERISTICS

Mod.
Boiler volume l
Operating pres- bar
sure
Steam temp. °C
Boiler abs. power W
Max mains im- Ohm
pedance
D e t . S o l u t i o n l
tank
Water tank l
D i s p e n s i n g W
pump
Weight Kg
Sound level Lp dB (A)
Lw dB (A)
TROUBLESHOOTING
Problem
The appliance does not start up.
Cause
No power. (Indicator "1" off)
Faulty cable or main switch.
Remedy
Make sure there is power.
Contact the service centre.
Problem
No detergent solution is dispensed.
Cause
Detergent solution tank empty. (Indicator "3" on)
Dirty and clogged accessories.
Clogged detergent solution intake circuit.
The pump is not delivering the solution.
Damaged dispensing pump.
Remedy
Fill the solution tank with detergent solution.
Clean the accessories.
See the section on filling the detergent solution intake circuit.
Contact the service centre.
Problem
Water leaks from the joints of the accessories.
Cause
Worn or leaking joint gaskets.
Remedy
Check, clean and lubricate the gaskets, replace if necessary.
English
Problem
The accessories do not fit perfectly.
Cause
SG 70
The connectors and quick couplings are dirty.
7
Remedy
9.0
Clean and lubricate the connectors and quick couplings.
160 Problem
No steam is dispensed.
12000
Cause
0.35
Boiler not yet at minimum pressure (indicator "4" off).
No power.
6
If the water tank is empty, indicator "2" comes on when the
steam switch is pressed.
Steam switch not pressed.
50
60x3
Remedy
Wait for a few minutes until light "4" on the control panel comes
on. If the problem continues, contact the service centre.
170
Check there is power and that the appliance is correctly plugged
72 (Kp 2)
into the mains socket.
81 (Kw 2)
Fill the water tank with clean water.
Check the switches are on.
Problem
No steam is dispensed and the pump continues to fill.
Cause
There is air in the boiler fill circuit.
The fill pump water filter is clogged.
Remedy
Avoid causing waves in the water tank.
Clean the fill pump water intake filter.
Perform the normal work cycle.
If the problem continues, contact a service centre.
Problem
The appliance does not work. Error #2 appears on the display.
Cause
Boiler filling system malfunction.
Remedy
Clean the fill pump water intake filter.
Perform the normal work cycle.
If the problem continues, contact a service centre.
Problem
The appliance does not work. Error #1 appears on the display.
Cause
Maximum boiler pressure exceeded. The safety pressure switch
has tripped.
Remedy
Press the button on the safety pressure switch to restore normal
functioning.
If the problem continues, contact a service centre.
- 18 -