hard water (> 15°TH), carry out maintenance more frequently.
The boiler's scaling should be made only by an authorized
assistence service.
This operation requires the machine to be located in the assi-
stence service.
For maintenance and/or repairs, use only original spare
parts which offer the greatest characteristics of quality and
reliability. Failure to use original spare parts absolves the
manufacturer from all liability and transfers it to the person
carrying out the operation.
STORAGE
If the appliance is not used for long periods, unplug it from the
mains socket, empty and wash the waste drum and clean the
boiler. Protect parts which might be damaged by dust. Empty
the water and cleaning solution tanks via the relative drainage
bungs. Rinse the cleaning product delivery circuit using clean
water.
When used again, check there are no cracks or cuts in the
vacuum and solution/steam emission tubes and attachments.
SCRAPPING
If you decide to stop using the steam generator, you should
render it inoperative by removing the electric power cable. Parts
which might constitute a danger, especially to children playing
with the appliance, should be made harmless.
This product is classified as WEEE type special waste and is
covered by the requisites of the new environmental protection
regulations. It must be disposed of separately from ordinary
waste in compliance with current legislation and standards.
Do not use the components removed as spare parts.
TECHNICAL CHARACTERISTICS
Mod.
Boiler volume
l
Oper. pressure
bar
Steam temp.
°C
Abs. power. boil.
W
Max. all. imped-
Ohm
ance
Solut. tank
l
Water tank
l
Del. pump
W
Weight
Kg
Noise level
Lp dB (A)
Lw dB (A)
English
SG
SG
SG
5008
5010
5014
4
4
5
5,0
5,0
7,0
160
160
160
2900
3660
7100
0,35
0,35
6
6
6
6
6
6
60+60
60+60
60x3
35
35
36
72 (Kp 2)
81 (Kw 2)
TROUBLESHOOTING
Problem
The appliance does not work.
Cause
No voltage.
Faulty cable or mains switch.
Remedy
Make sure there is voltage.
Contact the service centre.
Problem
Water comes out of head (air output)
Cause
Collection drum too full.
Remedy
Empty drum and check float. Clean if necessary.
Problem
No chemical product delivered
Cause
Solution tank empty. (Intermittent beep)
Attachments dirty or clogged.
Detergent intake circuit clogged.
Pump does not suck.
Damaged delivery pump.
Remedy
Fill the solution tank with cleaning product.
Clean attachments.
See paragraph on filling the cleaning product suction circuit.
Contact the service centre.
Problem
Considerable drop in suction power.
Cause
Clogged or broken tubes, hose or attachments.
Drum too full.
Head not perfectly adhering.
Remedy
Clean or replace tubes or accessories.
Empty drum.
Check adherence of head to drum and check that hooks fit
correctly.
Problem
Engine turns quickly (high pitched noise).
Cause
Clogged tubes or accessories
Drum too full.
Remedy
Clean tubes or accessories.
Empty drum.
- 16 -