Ge Ethernet Mode - Optika Italy H Serie Manuel D'instructions

5.2.4 GE Ethernet Mode

This application uses the camera as the network camera. User must configure the IP of the camera and PC
manually and ensure their IP addresses are in the same net. The subnet mask and gateway of the camera and
PC must be the same.
1. Plug the HDMI cable into the HDMI port ③ to connect the C-H4K camera to HDMI display.
2. Plug the USB mouse into USB Mouse port ① to get control of the camera by using built-in software ProView.
3. Plug 12V/1A power adapter into DC 12V slot ⑧ to supply power for the camera. The LED Indicator ⑦ will
turn into red.
4. Press ON/OFF Button ⑥ to turn on the camera. The LED indicator will turn into blue.
5. Move the mouse to the bottom of the UI and clicking the
bottom of the video window. A small window called Settings will pop up as shown below.
6. Click the LAN property page, uncheck the DHCP item. Input the IP Address, Subnet Mask and Default Gate-
way for the camera.
7. Designate the Internet Protocol Version 4 (TCP/IPv4) Settings page's IP address on the PC with similar con-
figuration as shown below but with different IP address.
Figure 3 - IP Camera configuration
Figure 4 - PC's IP configuration
Page 7
button on the Camera Control Toolbar at the