To Light; To Turn Off - Coleman 2000010870 Notice D'emploi

Réchaud à butane
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To Set Up
■ Close cartridge
compartment.
NOTE:
If compartment
will not close,
check to be sure
lever is in "
"
position. If the
problem persists,
take the stove
back to your dealer.
Failure to follow these procedures to properly
install the cartridge and close the door can
result in a gas leak.

To Light

WARNING
If you smell gas:
1. Do not attempt to light appliance.
2. Extinguish any open flame.
3. Disconnect from fuel supply.
4. Call 1-800-835-3278.
To Light
■ The stove must not be
exposed to flammable
vapors or liquids
during lighting. This
stove is equipped with
a piezo electric igniter.
■ Pull the Lever down to
the "
" position.
■ Turn Control Knob
counterclockwise
until you hear a click
indicating that a spark
has been produced.
■ If the stove does not
light, turn the Control
Knob back to ( )
position and repeat
previous step.
■ After three (3) failed
attempts, turn the gas
supply off by turning the
Control Knob clockwise
to ( ) position and return
Lever to the up position.
■ Open door, remove
cartridge and shake to
verify that it is not empty.
CAUTION: When cartridge
needs to be replaced: if stove
in use, do not touch the hot stove or any items that are on
the stove until they have cooled.
■ If empty, replace cartridge following the "To Set Up"
section on page 4.
■ Adjust flame with
Control Knob.
■ Flame should be blue
with hint of yellow
on tips.
■ When ignitor is not
working, please use
the match light to
return to the manufacturer.
■ Match lighting instruction:
Install the cylinder and pull the Lever down to "
Step 1: Turn the control knob counter-clockwise slowly.
Step 2: Place lit match near the burner.
Step 3: After the burner light, turn the control knob to your
desired position.
WARNING
BURN HAZARD
• Never leave stove unattended when hot or in use.
• Keep out of reach of children.

To Turn Off

■ Turn Control Knob
clockwise to ( ) position
and return Lever to the up
position to disconnect
the cylinder.
" position.
5

Publicité

Chapitres

Table des Matières
loading

Table des Matières