Makita GB602 Manuel D'instructions page 9

The angle adjustment can be made by loosening the hex
bolts on the bevel scale plate. After adjusting the angle,
tighten the hex bolts securely.
2
1
4
5
Loosen the wing nut B and slide the holder B so that the
"gullet" or slot between the saw blade Teeth just comes in
contact with the edge of the Wheel. Slide the stopper so
that it comes in contact with the holder B and tighten the
wing nut B securely.
WARNING:
Always disconnect the bench grinder from the power
source before performing any assembly or adjustment.
Failure to do so could result in accidental starting resulting
in possible serious personal injury.
WHEEL REPLACEMENT
See Fig.13.
If you must replace a grinding wheel, be sure to obtain
one with a safe rated speed at least as high as the "no
load speed" RPM marked on the data plate of the grinder
and which is marked to comply with EN12413.
WARNING:
When servicing, use only manufacturers recommended
replacement parts. Use of other part may create a hazard
and cause product damage.
GENERAL
Keep the bench grinder clean. Remove dust from working
parts and beneath the grinder frequently.
Make sure the bench grinder operates properly. Check
screws, nuts, and bolts for tightness.
EXTENSION CORDS
The use of any extension cord will cause some loss of
power. To keep the loss to a minimum and to prevent tool
overheating, use an extension cord that is heavy enough
to carry the current the tool will draw.
An extension lead of cross sectional area of at least
2
1.5 mm is recommended for an extension cord 8 meters
or less in length. When working outdoors, use an
extension cord that is suitable for outdoor use.
WARNING:
Check extension cords before each use. If damaged,
replace immediately. Never use tool with damaged cord
since touching the damaged area could cause electrical
shock resulting in serious injury.
1. Saw blade
3
2. Screw
3. Grinding wheel
4. Wing nut A
5. Holder A
Fig. 12
MAINTENANCE
To replace the grinding wheel, remove the wheel cover by
loosening the nuts.
Loosen the wheel nut in a clockwise direction for the left
side and a counterclockwise direction for the right side
using the correct wrench. Remove the outer flange and
grinding wheel. To install a new grinding wheel, reverse
the above procedure.
Be sure the grinding wheel and outer flange are properly
seated on the spindle shaft.
1
WORKLIGHT BULB REPLACEMENT
1
When the light bulb is worn out and no longer working,
unfasten the screws which fix the lamp cover, then gently
remove the bulb from the holder by pushing in and turning
anticlockwise. Contact your dealer for replacement part.
To replace, gently push the light bulb into the insert and
turn clockwise, then fix the lamp cover in the revise order.
WHEEL DRESSING TOOL (Accessory)
Dressing a wheel is done to renew sharpness or to true up
the face of the wheel.
Set the work rest of the bench grinder at a slight angle
and brace the wheel-dressing tool against it. Do not make
contact with the grinding wheel until after you have turned
on the motor and the wheel is rotating at full speed. Press
the dressing tool slightly against the rotating wheel until
you get a bite, then move slowly from side to side across
1. Wrench
2. Wheel cover
2
1
Fig. 13
1. Wrench 13
2. Wrench 19
GB801 only
2
1. Wrench 17
2. Wrench 24
Fig. 14
1. Light bulb
Fig. 15
9