Suntec Wellness KLIMATRONIC Heat Safe 1000 PTC-Turbo Mode D'emploi page 12

Table des Matières

Publicité

Repeat steps 2,3 and 4 for the second wheel
base. Both wheel bases should be installed on
the utmost radiator fins to avoid tilting.
Operation
Operating voltage: 220-240V, ~50Hz, 1000W (model Heat Safe 1000 PTC-Turbo)
Heating:
1. Before operation, place the appliance in an upright position on a flat, stable and heat-resistant surface.
Make sure no flammable objects are near in a radius of 1 meter.
2. Turn the thermostat control to "min" and the power rotary switch to "0". Afterwards insert the power
plug into a wall socket.
3. At the power rotary switch, choose between "
●●●
"
" (maximum heating level).
4. If you keep on turning the power rotary switch, you can turn on the heating ventilation "
accelerate the room heating and can be intensified by adding the highest heating level „
5. Please turn the thermostat control to "max". The lamp at the appliance will light up. When the room has
reached a comfortable room temperature, turn the thermostat control counter-clockwise until the lamp
goes off. If you wish to increase the temperature, turn the control clockwise. If you wish to decrease
the temperature, turn the control counter-clockwise.
Please note: While turning the thermostat control, the lamp will only light up if the selected temperature
is higher than the room temperature.
6. To turn off the appliance, turn the power rotary switch to "0".
Time switch:
1. Each time switch segment represents a time period of 15 minutes. The entire dial represents a 24 hour
day.
2. Please set the current time by turning the dial clockwise until the arrow points at the current time (see
picture 1).
3. Please select the time segments at which the appliance shall turn on and push the according segments
outwards (see picture 2).
4. For the time segments at which the heating shall turn off, push the segments inwards. In the example
in picture 3 the current time is 9AM, the heating period is from 9AM until 1PM and the heating is turned
off from 1PM until 8:59AM.
Picture 1
After correct installation, the appliance should look
like the picture above. Now, turn the appliance back
on its feet. The appliance should have a stable
stand and, due to the wheels, be movable. Please
remove the carpet before using the appliance.
1500W (model Heat Safe 1500 PTC-Turbo)
2000W (model Heat Safe 2000 PTC-Turbo)
2500W (model Heat Safe 2500 PTC-Turbo)
" (low heating level), "
Picture 2
●●
" (medium heating level) and
". This will
Picture 3
".

Publicité

Table des Matières
loading

Table des Matières