Controls And Functions; Front Panel - Yamaha RX-797 Mode D'emploi

Front panel

1 2 3
MASTER SPEAKERS
A B
ON OFF
INPUT
MAIN ZONE
ON/OFF
F
1 MASTER ON/OFF
Press inward to the ON position to turn on the power of
this unit. Press again to release it outward to the OFF
position to turn off this unit.
See page 17 for details.
Note
Even when this unit is turned off, this unit consumes a small
amount of power to preserve the memory.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost. However, the stored data will be lost if
the power cord is disconnected from the AC wall outlet
for more than one week.
2 MAIN ZONE ON/OFF
Turns on Main Zone of this unit or sets it to the standby
mode.
See page 17 for details.
Notes
• This switch is operational only when MASTER ON/OFF is
pressed inward to the ON position.
• In the standby mode, this unit consumes a small amount of
power to receive infrared signals from the remote control.
3 SPEAKERS A/B
Turns on or off the speaker set connected to the
SPEAKERS A and/or SPEAKERS B terminals on the rear
panel each time the corresponding button is pressed (see
page 18).

CONTROLS AND FUNCTIONS

4 5 6
ZONE 2 ON/OFF
ZONE CONTROL
A/B/C/D/E 1 2
CATEGORY
REC OUT BASS
CD
0
PHONES MD/TAPE XM 1 1
VCR TUNER 2
DTV/CBL PHONO 3
DVD
4
– 5 5
G H I J
7 8 9
FM/AM l TUNING/CH h
XM/ANT
EDIT MEMORY
SEARCH MODE MAN'L/AUTO FM
3 4 5 6 7
DISPLAY
TREBLE BALANCE LOUDNESS
0 0
1 1 1 1 1
2 2 2 2 2 2
3 3 3 3 3 3
4 4 4 4 4 4
+ – 5 5 + L 5 5 R 5
K L
4 ZONE 2 ON/OFF
Turns on Zone 2 or set it to the standby mode. When Zone
2 is turned on, signals are output at the ZONE 2 OUT
jacks.
Note
This switch is operational only when MASTER ON/OFF is
pressed inward to the ON position.
5 ZONE CONTROL
Press to control the input source of Zone 2.
Notes
• This button is operational only when Zone 2 is turned on.
• When you press this button, the ZONE 2 indicator flashes in the
front panel display for approximately 5 seconds. Select the
input source of Zone 2 while the indicator is flashing.
• You can select the preset station or channel when TUNER or
XM is selected as the input source of Zone 2.
6 Remote control sensor
Receives infrared signals from the remote control.
Note
Switch the remote control ID between ID1 and ID2 when using
multiple YAMAHA receivers or amplifiers (see pages 9, 39 and
40).
7 Front panel display
Shows information about the operational status of this
unit.
CONTROLS AND FUNCTIONS
0 A B C D
PURE DIRECT CD DIRECT AMP
TUN MODE/DISP
AUTO/MAN'L
16 16
20 20 12 12
8 VOLUME
26 26
FLAT 40 40
–30dB
10
9
60 60
8 ∞
0
7
6 -dB -dB
(U.S.A. model)
M N
E
8
4
2
3