Xm Satellite Radio; Remote Control - Yamaha RX-797 Mode D'emploi

Masquer les pouces Voir aussi pour RX-797:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TROUBLESHOOTING

■ XM Satellite Radio

Error message
CHECK ANTENNA
UPDATING
NO SIGNAL
LOADING
OFF AIR
<XM> - - -
- - - / - - -
<CAT> - - -

■ Remote control

Problem
The remote control
does not work nor
function properly.
48
Cause
The XM Connect-and-Play digital antenna
accessory is not connected, or does not work
properly.
The XM user encryption code is being updated.
The signal is too weak.
It takes longer than four seconds for audio or
text data to be decoded.
The XM Satellite Radio channel you selected is
not currently broadcasting any signal.
The channel station ID (SID) is no longer
available.
No artist name/feature or song/program title is
available.
No channels are available for the selected
category.
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The remote control ID and this unit's ID
do not match.
The remote control code was not correctly
set.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
Check the XM Connect-and-Play digital antenna accessory
connections.
Wait until the encryption code is updated.
Check the XM Connect-and-Play digital antenna accessory
connections and orient it for the best reception.
Wait until the decoding process has finished.
Check the channel number again or select another XM
Satellite Radio channel.
Select another channel category by pressing CATEGORY on
the front panel (or A-E/CAT. j / i on the remote control)
repeatedly.
Remedy
The remote control will function within a maximum
range of 6 m (19.7 ft) and no more than 30 degrees
off-axis from the front panel.
Reposition this unit.
Replace all batteries.
Switch the remote control ID or this unit's ID.
Try setting another code of the same manufacturer
using "LIST OF REMOTE CONTROL CODES" at
the end of this manual.
Use the supplied remote control for the components.
Remedy
See
page
11
11
9, 39, 40
45

Publicité

Chapitres

Table des Matières
loading

Table des Matières