EdilKamin BERING Installation, Usage Et Maintenance page 41

FIG. 1
A
D
B
G
E
F
STEP 2
*
Y
STEP 4
D
D
*
STEP 6
C
INSTALLATION
STEP 1
H
C
STEP 3
A
STEP 5
STEP 7
BUILT-IN WALL INSTAL-
LATION OF DOMOKLIMA
GRAPHICA CONSOLE
Material needed (fi g. 1):
- Control panel with display (A)
B
- Plastic casing for built-in fi tting (B)
- Aesthetic fi nishing plate (C)
- 2 self-threading screws and wall plugs (D)
- Aesthetic plastic wall casing (E)
*
- Plastic base for wall fi tting (F)
- Protective cover for wall fi tting (G)
- BUS connection wire (H)
STEP 1
The kit also includes a coated wire with
diameter of about 4.5 mm with a connec-
tor with dimensions of 6.8mm x 9.7mm x
4.5mm and total length of about 10 m.
Bring the wire (*) coming from the boiler
to the built-in wall compartment of the
console.
Insert the wire into the appropriate hole in
the plastic casing (B).
STEP 2
After positioning the wire, connect it to
the connector (Y) located on the rear part
of the control panel with display.
(take care that the connector is correctly
* positioned)
STEP 3
Position the control panel with
display (A) into the seat of the plastic
casing.
(N.B. Pay attention to the electrical con-
nections)
The side with the keys must be on the part
of the opening which allows the passage
of the wire.
STEP 4
Fix the control panel with display to
the plastic casing with the 2 screws (D)
provided.
(N.B. only on the side towards the open-
ing which allows the passage of the wire).
STEP 5
Fix the assembled components into the
seat for wall fi tting, with two screws (not
provided).
STEP 6
Click on the aesthetic fi nishing plate (C),
pushing it onto the plastic casing.
STEP 7
The control panel thus installed is ready
for use (after having connected the wire to
the boiler itself).
- 41
-