NSK Ti-Max nanoSG20LS Manuel D'opération page 5

3.Connection & Disconnection of the Handpiece and Motor
3-1 Connection
1) Connect the handpiece direct to the motor and twist the handpiece until it locks into position with a
clicking sound.
2) Make sure the handpiece is firmly connected to the motor.
3-2 Disconnection
Hold the motor and the handpiece separately and disconnect with care.
CAUTION
• Disconnect the handpiece only after the motor has completely stopped rotating.
• This handpiece can ONLY be connected to E type motors in accordance with ISO 3964 with a motor insert length of 23mm or
• less.
4
nano Handpiece Motor
23mm
Fig. 1