Disposal - Hilti TE 76 Mode D'emploi

ity to use the tool for any purpose. Implied warranties
of merchantability or fitness for a particular purpose
are specifically excluded.
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.

Disposal

Most of the materials from which Hilti power tools are manufactured can be recycled. The materials must be cor-
rectly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking
back your old electric tools for recycling. Please ask your Hilti customer service department or Hilti sales repre-
sentative for further information.
Should you wish to return the electric tool yourself to a disposal facility for recycling, proceed as follows: Dismantle
the tool as far as possible without the need for special tools. Use absorbent paper to wipe lubricated parts clean
and to collect the oil that runs out (total quantity approx. 3 cu.inches ). This paper should also be disposed of cor-
rectly. On no account should oil be allowed to enter the waste water system or to find its way into the ground.
The individual parts should be separated as follows:
Part / assembly
Toolbox
Outer casing
Inner casing
Grip, side handle
Electronics box
Motor housing
Motor end cap
Fan
Motor (rotor and stator)
Supply cord
Gearing parts, hammering mechanism parts
Con-rod and drive piston
Screws, small parts
8
Printed: 07.07.2013 | Doc-Nr: PUB / 5071196 / 000 / 00
Main material
Plastic
Plastic
Magnesium alloy
Plastic
Various
Plastic
Plastic with steel part
Plastic
Steel and copper
Copper, elastomer sheath
Steel
Plastic
Steel
Recycling
Plastic
Plastic
Scrap metal
Plastic
Electronic scrap or metal scrap
Plastic
Scrap metal
Plastic
Scrap metal
Scrap metal
Scrap metal
Plastic
Scrap metal