Specific Safety Rules And Symbols; Description - Hilti TE 76 Mode D'emploi

5. Service
Tool service must be performed only by qualified repair
personnel. Service or maintenance performed by un-
qualified personnel could result in a risk of injury.
When servicing a tool, use only identical replacement
parts. Follow instructions in the Maintenance section
of this manual. Use of unauthorized parts or failure to
follow maintenance instructions may create a risk of
electric shock or injury.

Specific safety rules and symbols

Hold tool by insulated gripping surfaces when per-
forming an operation where the cutting tool may con-
tact hidden wiring or its own cord. Contact with a "live"
wire will make exposed metal parts of the tool "live" and
shock the operator.
Wear ear protectors when using the tool for
extended periods. Prolonged exposure to high
intensity noise can cause hearing loss.
Use the tool only for purposes for which it is designed.
Failure to do so may result in electric shock, damages
to property and/or serious personal injury.
Always hold tool in both hands when it is in use. Always
use the side handle. Ensure that the side handle is fit-
ted correctly and tightened securely
handle at its outer end
tion at all times. The drill bit may become stuck anytime,
which may result in the tool twisting if it is not properly
held.
Unplug tool immediately if supply cord becomes
damaged during working. Have supply cord replaced
by a qualified electrician. Damaged supply cords pre-
sent a risk of fire and/or electric shock.
Never operate the tool when it is dirty or wet. Dirt/dust
or dampness on the surface of the tool make it slippery
and difficult to hold and may, under unfavourable con-
ditions, present a risk of electric shock.
Ensure that the insert tools are equipped with the appro-
priate connection end for the chuck system in use and
that they are locked in position correctly in the chuck.
Inserting tools with a different connection end will result
in malfunction and damage to the tool and may even
cause injury by breaking parts. Incomplete insertion may
result in insert tool falling out of chuck, causing dam-
age or injury to persons.
Printed: 07.07.2013 | Doc-Nr: PUB / 5071196 / 000 / 00
. Hold the side
when drilling and pay atten-
Symbols used on the tool:
V ............................
~ ............................
Hz ............................
W ............................
A ............................
n ............................
0
n ............................
/min ............................
∅
............................
............................

Description

The TE 76 / TE 76P / TE 76-ATC / TE 76P-ATC is an
electrically powered rotary hammer and breaker with
pneumatic hammering mechanism designed for pro-
fessional use.
The following items are supplied: power tool, operating
instructions, grease (50 ml), cleaning cloth, toolbox.
See figure and the explanations of operating controls
and the tool components on page 1.
The following conditions must always be observed
when the tool is in use:
– The tool must be connected to an alternating current
electric supply in compliance with the information
given on the type plate.
– The tool is for hand-held use only.
– The tool must not be used in places where the sur-
rounding conditions may present a risk of explosion.
volts
alternating current
hertz
watts
amperes
no load speed
speed under normal load
revolutions per minute
diameter
protective grounding
3