Problems - Sagem PHOTO EASY 155 Livret D'utilisation

Remark: The printer is fitted with an automatic time-out to prevent overheating, this can be tripped when performing large
print jobs. The printer automatically restarts the current print job as soon as the temperature drops back to nor-
mal.
No mains supply (indicator
lamp off)
The light (indicator lamp red)
The printer was unplugged
during a print job
No photograph is printed on a
sheet
The photograph is marked
with a continuous line or a lot of
spots
No PC printing
Photo chronology not observed
(the printed photo is not the
one expected)
P
ROBLEMS
P
ROBLEMS
• Check that the power supply block is correctly plugged into the
mains.
• Check that the power supply connector is correctly plugged into
the printer.
• Checkthat the mains socket is live (check fuses and/or circuit
breakers of your installation as necessary).
• Refer to the error table below (Refer to paragraph Error messages,
page -27).
• Set the printer on/off switch to "o" and then reconnect the mains
lead.
• Switch on the printer and wait for the initialisation phase to be
completed.
• If a sheet of paper is jammed, carry out the procedure (Refer to
paragraph Paper jam, page -25).
• Restart printing.
• Are you using sheets that meet the technical specifications (Refer
to paragraph Technical data, page -29)
• Have the sheets been inserted shiny face up?
• Clean the printhead (Refer to paragraph Cleaning the print head,
page -24).
• Check that the USB cable is correctly connected.
• Is the printer driver installed?
• You must set the date and time on your camera beforehand, and
activate them before photographing.
- 26 -
S
OLUTIONS