Maintenance; Cleaning The Print Head - Sagem PHOTO EASY 155 Livret D'utilisation

7 M
AINTENANCE
Continuous lines across the length of your photographs may be caused by dirt particles stuck to the
printhead.
1 - Open the cartridge flap. Press on the locking lever and pull out the film cartridge.
2 - Pull out the paper tray.
3 - Turn the printer upside down to remove the lower hatch.
4 - Clean the heating line of the print head carefully using a cotton bud.
5 - Replace the lower hatch, turn the printer right side up, connect the mains cable and switch on the
printer.
Warning -
1.
C
LEANING THE PRINT HEAD
You will need a methylated alcohol
("Q-tips").
Switch off your printer, disconnect the main cables and wait for five minutes; since the print head
operates at a high temperature, there is a risk of burning if you touch it.
Never touch the print head with your fingers or any object that might scratch it.
1
4
Replace the film cartridge. Take care that the film is taut before inserting the cartridge into its
compartment. Check that the locking lever is pushed down correctly and close the flap.
Push the paper tray back into place until the locking system clicks.
Do not use corrosive chemicals, they may damage your printer.
1
based cleaning product and some off-the-shelf cotton tips
2
5
- 24 -
3