Installing The Remote Control - Grohe Sensia ARENA Série Manuel D'installation

Installing the Remote Control

Insert the batteries.
Decide the installation position of the remote control.
Mount the standard remote control holder onto the
wall.
Mounting the holder using screws
-1 For plasterboard or plywood that is thinner
than 5mm
-2 For concrete
Mounting the holder using double-sided tape
Note
• Clean the installation wall/adhesive-facing surface,
free from dust, debris, and water.
• Insufficient cleanliness may weaken the
adhesiveness of the double-sided tape.
• Press the holder enough to installation wall/
adhesive-facing surface to make sure that holder is
securely attached.
• Double-sided tape may come off in high temperature
or hight humidity environment.
Attach the remote control to the holder.
Testing
Cover the seat sensor with a piece of rag or paper
and place the spray hood under the toilet seat.
Switch the POWER of the E-bidet (seat unit) to on (|).
Then bring remote control near to the toilet and press
OK to pair.
Confirm that water sprays for rear and front washing.
Remove the spray hood.
Press dryer button and check if it works properly.
Attach the banderole to the seat lid.
12
GB