Grohe Sensia ARENA Série Manuel D'installation page 11

Do not damage, bend, modify,
excessively twist, bind, sandwich, or
place heavy objects on the power
cord.
There is a danger of fire or electric
shock due to the cord becoming
damaged.
Do not install this product in a wet or
damp location, such as inside a
shower room or steam room, as this
may lead to electric shock or fire.
Do not attach the product to any
water source other than potable
water.
It may cause electric shock, fire and
skin inflammation due corrosion of
electronic parts inside the seat unit.
In regions where the carbonate
hardness exceeds 18° dH (KH), a
water filtration system with water
softener must be used. You can
inquire about your carbonate
hardness with your local utilities
provider.
In order to ensure the long service
life;
– Please perform the descaling every
3 years (Please purchase descaling
kit sold separately. Product number
is 46978001).
– Please replace the nozzle tip every
3 years (Nozzle tip is included in
the descaling kit. Please purchase
descaling kit sold separately.
Product number is 46978001).
CAUTION
Install a high-sensitivity, high-speed
ground fault circuit interrupter (with
rated current value of 15 mA or
below) on the primary side of the
power supply.
There is a danger of electric shock.
The toilet bowl is made of ceramics,
and ceramics are fragile. Note the
following when handling the toilet
bowl:
– Prior to installation, make sure that
the toilet bowl is in a good condition
and not damaged.
– After installation, check the toilet
bowl for any damages.
Failure to do so may cause injury, or
water leakage and/or flooding.
Wash out foreign materials or rust
inside the pipes before connecting
the product.
Failure to do so could damage the
internal parts of the product, which
may cause water leakage and/or
flooding.
Note the following when using the
strainer:
– Close the water shutoff valve when
removing the strainer.
– When installing the strainer, tighten
it fully so there is no gap.
– Check that the O-ring is free from
foreign materials when attaching it.
If foreign materials are attached to
the O-ring, it may cause flooding
due to water leakage.
Adjust the water shutoff valve and
check for water leakage after the
installation.
It may cause water leakage and/or
flooding.
8
GB