Grohe Sensia ARENA Série Manuel D'installation page 14

Installing the Ceramic Bowl
Remove the packaging on the ceramic bowl.
Note
• Keep the packaging until installation is finished.
Prepare and cut the water supply pipe and drain pipe
(supplied with the tank) to the necessary length.
Attach the protection sheet to the wall.
Insert the water supply pipe and drain pipe.
Place the ceramic bowl to approximately 100 mm from
the wall. Then pull the power cord and the water
supply hose into the ceramic bowl.
Secure the ceramic bowl onto the wall.
Note
• Secure the ceramic bowl using the hexagonal nuts
supplied with the tank.
Check whether the ceramic bowl is horizontally flat.
Note
• If necessary, adjust the flatness of the bowl by
loosening the hexagonal nuts in step
Remove the packaging under the ceramic bowl.
Cut the protection sheet sticking out around the
ceramic bowl.
Seal the edges where the protection sheet, toilet, and
wall meet.
11
GB
Thread the power cord and water supply hose.
Connect the power cord.
For the Standard (39354SH1) model
Connect the water supply hose, and secure it with the
clip. Check if the water supply hose is properly
secured with the clip.
Note
• If the clip has not attached properly, remove it and
attach it again. To open the clip, insert a flat-blade
screwdriver and then press it downward and push it.
For the Display (18801SH1) model
Attach the strainer.
For the Standard (39354SH1) model
Twist the lever of the water supply hose vertically.
For the Display (18801SH1) model
Thread the tube and place the E-bidet (seat unit) on
top of the ceramic bowl.
.
Slightly tilt the back of the E-bidet (seat unit) and
insert it into the ceramic bowl.
Note
• Do not let the power cord hang in the ceramic bowl
when installing the E-bidet (seat unit).
• Make sure that the hooks under the E-bidet (seat
unit) are secured into the mounting base of the
ceramic bowl.
• When the E-bidet (seat unit) is locked, you will hear
a "click" sound.
• You can detach the E-bidet (seat unit) by following
the steps below.
Remove the side lid of the E-bidet (seat unit).
Press the lever. Use a screwdriver if you cannot
reach it by hand.
Pull the E-bidet (seat unit) out upward while
pressing the back part.
Store the power cord in the groove on the underside
of the bowl.
Open the water shutoff valve.
For GROHE tank, adjust the amount of flushing water.
Then reattach the actuation plate.
Turn on the power breaker.
Installing the E-bidet (Seat Unit)