Installing The Remote Control - Grohe Sensia ARENA 39354SH0 Manuel D'installation

Installing the Remote Control

Remove the remote control from the holder.
Insert the batteries.
Note
• Vertical lines may appear on the screen when the
batteries are removed. This is not a malfunction.
These vertical lines will disappear when batteries are
inserted into the remote control.
Insert the small nut into the groove on the back of the
remote control.
Decide the installation position of the remote control.
Note
• Leave a space above the remote control's mounting
position.
Mount the remote control holder onto the wall.
For plasterboard or plywood that is thinner than 5 mm
For concrete
Attach the remote control in the holder.
Secure the remote control to the holder with the small
washer and screw.
Testing
Cover the seat sensor with a piece of rag or paper
and place the spray hood under the toilet seat.
Switch the POWER of the E-bidet (seat unit) to on (|).
Then press the SETTING button ( ) of the remote
control to register it to the E-bidet (seat unit).
Confirm that water sprays for rear and front washing.
Remove the spray hood.
Confirm warm air. Attach the banderole to the seat lid.
13
GB