Shutting Down; Frost Protection; Maintenance And Care; Maintenance Intervals - Kärcher BRC 30 Mode D'emploi

Shutting down

Set the appliance switch to "OFF".
Empty the dirt water reservoir.
Pull the drain hose for the fresh water
off the hose nipple an drain the deter-
gent solution.
Cleaning the device
Fill the fresh water tank with approx. 2
liters of hot water (max. 60°C) and flush
the spray system by pressing the deter-
gent solution key.
Disconnect the mains plug from the
socket.
Pull the drain hose for the fresh water
off the hose nipple an drain the deter-
gent solution.
Clean the sieves on the fresh water
tank and inside the dome.
Rinse the dirt water tank with clear wa-
ter.
Tilt the appliance backwards and clean
the cleaning head and the vacuum bar..

Frost protection

In case of danger of frost:
Empty the fresh and dirt water reservoirs.
Store the appliance in a frost-protected
room.

Maintenance and care

Danger
Danger of injury by electric shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.

Maintenance intervals

Daily before use
Check high power cable, extension ca-
bles and hoses for damage every time
before use.
Check spray pattern of the nozzle.
Warning
Risk of damage. Never use a wire or a nee-
dle to clear plugged nozzles, but rinse them
with hot water (see "Troubleshooting").
Every 25 operating hours
Check hoses and seals to see if there
are damages. Have defective parts re-
placed by Customer Service.
Check the brushes for wear, replace if
required.
The brushes are considered worn, if the
bristles have the same length as the
yellow indicator bristles.
Maintenance Works
Replace the nozzle.
Empty the fresh water tank and waste
water reservoir.
Tilt the appliance backward and store it
on the pushing handle.
Unscrew and remove the left and right
screws on the cleaning head.
Remove the cleaning head.
1
2
3
1 Nozzle
2 Fastening clip
3 Hose clip
Pull the fastener clip off to the side.
Pull the nozzle backwards out of the
support plate.
Open the hose clip and pull the nozzle
off the hose.
Insert the new nozzle into the hose.
Assemble it back in the reverse se-
quence.
Note
When inserting the nozzle into the support
plate, watch for the correct alignement of
the nozzle.
13
English