Thermador PROFESSIONAL PRO GRAND Serie Instructions D'installation page 20

If range is already installed, refer to the manufacturer's
instructions to disconnect gas and power supplies. Move
range forward to gain access to rear of unit.
Figure 16: Backsplash with a Keep Hot Shelf
1. Locate wall studs. Wall studs are usually installed with
a 16'' (406 mm) or 24'' (1372 mm) space on center.
2. The height of the hood will determine the height of the
top edge of the Backsplash. The Backsplash should be
mounted so that the bottom rear edge of the Keep Hot
Shelf overlaps the Backsplash 1½'' (38 mm).
3. At the locations indicated in Figure 17, mount the lower
shelf brackets included with the Keep Hot Shelf
through the Backsplash and into the wall studs.
• Due to variable wall stud widths and varying
Backsplash widths, in some cases, only one wall
stud may be found at the mounting location.
4. Remove Backsplash protective covering.
Installation Instructions
5. Start with the Keep Hot Shelf Installation.
Figure 17: Backsplash with a Keep Hot Shelf
Keep Hot Shelf (KHS[36,42,48]QS)
Varies Varies Varies
Clip Rack Top
13 "
7 /8
Clip
(352 mm)
Rack
10 1 /8 "
4 1 /16 "
(257 mm)
(103 mm)
3 "
3 /4
(95 mm)
5 /8 "
(16 mm)
Backsplash
9 "
7 /8
(251 mm)
Rack
Keep Hot
13 "
1 /2
(343 mm)
i i h d
Figure 18: Keep Hot Shelf
English 19