Most components can be inspected by removing the hood. To inspect the head you must disassemble the component-carrying plate which can be hung on
hung on the burner body in two different positions to make work as practical as possible. The motor, transformer and solenoid valve are connected via a
connector while the photo-resistor is push-locked into place.
2) Undo the 4 screws of the plate, as indicated,
in order to access nozzle, electrodes and
pre-heater (if fitted).
Pump pressure
Burner flow-rate
bar
kg/h
6,24
5,62
12
5,20
4,16
3,54
NOTE:
The values indicated in the table are purely indicative;