Kohler K-5848 Instructions D'installation page 3

INSTALLATION
Cut along the inside of the template line labeled "Cut
Along This Line".
Position the template on the countertop. The centerlines
are provided on the template to help with alignment.
Check for adequate clearance between the fixture, faucet,
and backsplash (finished wall), and make sure the fixture
will not interfere with the cabinet during installation.
For multiple-bowl installations, additional support will
be required between bowls installed in countertops that
are less than 1" (2.5cm) thick.
For multiple-bowl installations, a minimum distance of
3-3/8" (8.6cm) is required between bowls.
Trace the cutout opening on the countertop with a soft
lead pencil. This is the CUTTING LINE.
Use the template faucet hole locations to locate the faucet
hole centerlines on the countertop. Re-check for
adequate clearance between the backsplash, faucet,
fixture, and cabinet.
Cut out all required openings in the countertop by cutting
inside the pencil line traced from the template. For
laminate-type countertops, make sure all exposed
non-laminated surfaces near the cutout area are finished
and sealed to prevent water absorption damage.
CAUTION: Risk of product damage. Do not cut,
drill, or sand the countertop while it is positioned
over the fixture.
Kohler Co., Kohler, WI U.S.A.
Faucet Centerline
Cutting Line
Faucet Centerline
3
Fig. #3
Fig. #4
Fig. #5
1007290-2-A